Xenon replacement lamp 180 Watts for SL102

To replace the 180w xenon lamp follow the instructions below.

1. Turn off the equipment and unplug the power supply cable from the unit.
2. Turn the unit upside down and remove all the screws (4 located at the corners) that hold the cover to the hosing.
3. Turn the unit to normal position and slide the cover as shown in the figure. Remove it completely.
4. Disconnect the lamp power supply connector.
5. Remove the lamp holder screw and take away the defective lamp.
6. Place the new 180W xenon lamp in the lamp holder as shown in pictures (lamp code part:
7. Fix the lamp by adjusting the lamp holder screw.
8. Connect the xenon lamp power supply connector (male) to the stroboscope female connector. Check that the cables are far from the fan.
9. Place the cover back.